Xycom 3510T System Manual page 75

3510/3510KP/3512/3512KP System Manual
11. Slide out the bulb assembly.
12. Slide the new assembly into the opening from which the old assembly was removed.
Xycom Automation recommends replacing both bulbs at the same time.
13. Repeat steps 10 through 12 to replace the bulb assembly on the right, outside edge of
the flat panel display.
14. Reverse steps 1 through 8 to reassemble the unit.
3512 Units
Mitsubishi TFT Flat panel Display (Model #AA12SB6C-ADFD)
1. Turn off the power source.
D-2
Figure D- 1. Model #LQ10D421 Bulb Assembly
Note