Table of Contents
Advertisement
WHA-ADP-*
Configuration
5.6
Device Variable Mapping
The adapter can output the value and status of several variables, but a maximum of only
four variables can be published on the network. The device variable mapping is used to
configure these variables.
Figure 5.7: Device variable mapping
The variables that can be set as SV, TV and QV are as follows:
•
Temperature
•
Temperature min
•
Temperature max
•
Battery voltage
•
Consumer energy
•
RSL of best neighbour (RSL = Radio Signal Level)
•
RSL of second best neighbour
•
Battery voltage with load
•
Battery voltage without load during battery test
•
Normalized Consumer Energy
•
Estimated Lifetime
51
Advertisement
Table of Contents
