Installing An Atm Interface Module Into The 16-Slot/8-Slot Chassis; Installation Equipment; Preparing The Chassis - 3Com CoreBuilder 9000 Getting Started Manual

52 C 4: I
HAPTER NSTALLING AND
Installing an ATM
Interface Module
into the
16-Slot/8-Slot
Chassis
Installation
Equipment

Preparing the Chassis

R ATM I
EMOVING THE NTERFACE
After you have installed the daughter cards into the ATM Interface
Module, the Module is ready to be installed into the CoreBuilder 9000
16-slot chassis. This section describes how to install an ATM Interface
Module into the 16-slot chassis. The instructions for installing an ATM
Interface Module into an 8-slot chassis are identical.
To install an ATM Interface Module, you need:


The ATM Interface Carrier Module with daughter cards installed


A #2 flat-blade screwdriver
The following slots are available for installing the ATM Interface Module:
slots 1 through 7, 10, 12, 14, and 16. Slot numbers are located on the
top of the chassis for easy identification (Figure 32).
The CoreBuilder 9000 16-slot chassis is shipped with slot 1 open; a blank
faceplate covers the remaining ATM Interface Module slots. You normally
install the first ATM Interface Module in slot 1.
M
ODULE