Removing An Atm Interface Module From The 16-Slot/8-Slot Chassis - 3Com CoreBuilder 9000 Getting Started Manual

58 C 4: I
HAPTER NSTALLING AND
Removing an ATM
Interface Module
from the
16-Slot/8-Slot
Chassis
R ATM I
EMOVING THE
Figure 37 Tightening the Screws
CAUTION: To ensure adequate cooling air flow in the chassis, make sure
that blank faceplates cover all empty slots.
You can remove an ATM Interface Module while the system is on.
To remove an ATM Interface Module:
1 Record the cabling scheme.
2 Disconnect all cables from the ATM Interface Module's ports.
3 Loosen the two captive screws that secure the ATM Interface Module to
the chassis (Figure 38).
M
NTERFACE ODULE