3Com CoreBuilder 9000 Getting Started Manual page 29

Installing the OC-3c/STM-1 Daughter Card or OC-3c SMLR Daughter Card
Figure 6 Inserting the OC-3c/STM-1 Card into the Cutouts
x
3 Lower the OC-3c/STM-1 card until its beige bridge connector is aligned
over the beige bridge connector of the ATM Interface Carrier Module.
4 Place your fingers on the daughter card directly over the middle of the
beige bridge connector and press down to fasten the connectors
together (Figure 7). A click is heard when the connectors engage.
Figure 7 Fastening the Beige Bridge Connectors
click
29