Removing The Oc-12C/Stm-4 Daughter Card; Equipment Required - 3Com CoreBuilder 9000 Getting Started Manual
Atm interface module
Hide thumbs
Also See for CoreBuilder 9000:
- User manual (468 pages) ,
- Device view user manual (52 pages) ,
- Installation manual (33 pages)
Table of Contents
Advertisement
Removing the
OC-12c/STM-4
Daughter Card
Equipment Required
6 Insert the following screw and washer combination in the one hole on
the center of the daughter card (Figure 19):
a One flat washer
b One spring washer
c One panhead Phillips-head screw
Figure 19 Inserting the Screws and Washers
This section describes how to remove the OC-12c/STM-4 daughter card.
To remove the OC-12c/STM-4 card you need:
A #1 Phillips screwdriver
The antistatic bag that the OC-12c/STM-4 card was shipped in
The protective faceplate (if you are removing and not replacing the
module)
Removing the OC-12c/STM-4 Daughter Card
39
Advertisement
Table of Contents
Need help?
Do you have a question about the CoreBuilder 9000 and is the answer not in the manual?