Table of Contents
Advertisement
`
Your Smart Energy
Installation
Figure 2.18 Taking out the battery
Step 3: Open the battery package. Pull off the buckle located in the middle of the bottom. Pull the top
two guide rods to remove the front panel, as shown in Figure 2.18.
NOTE: The box must be placed in the direction of the label and only remove the packaging in
upwards direction. Removing the packaging in other directions is wrong.
Step 4: Unscrew the four screws on the bottom of M4856-P. Place the battery holder near the position
limiter.
Step5: Drill in the holes of the battery holder. Insert the expansion pipe into the drilled hole. Then pass
the tapping screw through the spacer and tighten it with the cross screwdriver
___________________________________________________________________
Alpha ESS Co., Ltd.
Page 21 of 46
Hide quick links:
Advertisement
Table of Contents
