Setting The Handlebars - Hercules Montfoort Operating Instructions Manual

6.2
Table 28:
CAUTION
!
034-11572_1.0_29.08.2018

Setting the handlebars


The handlebars must only be adjusted while the
bicycle is stationary.
 Unfasten and adjust the designated screw
connections, and clamp them with the maximum
tightening torque for the clamping screws of the
handlebars.
Maximum tightening torque for the
clamping screws of the handlebars*
*if there is no other data on the component
Handlebars clamping screw maximum tightening torque
Adjusting the stem
Crash caused by loose stem
Incorrectly fastened screws may come loose due to
impact. The stem may no longer be firmly fixed in its
position as a result. This will result in a crash and
injuries.
 Check the handlebars and the quick release system
are firmly in position after the first two hours of
riding.
Before the fist ride
5 Nm - 7 Nm
85