NEC DS1000 Correspondence Course Workbook page 143

Program 1804 - Extension Trunk Group Access
NEC America
DS1000/2000 Correspondence Course
Use this program to assign the outgoing access to trunk groups.
Incoming trunk group access is always allowed.
1. Enter the programming mode.
2. 1804 +
HOLD
1804:LINE GRP ACCESS
STATION #?nnn
3. Enter the extension number you want to program +
OR
Press to select extension 300.
HOLD
1804: STA nnn
LINE GROUP?n
The previously programmed value displays.
4. Enter the number of the trunk group (0-8) you want to program +
OR
Press to select trunk group 1.
HOLD
1804:STA:nnn GRP:n
LINE GROUP n:nnn
The previously programmed value displays on the second line. The
first line of the display shows the extension and trunk group you are
programming.
5. Enter Y to allow or N to prevent outgoing access to the trunk group selected +
VOL
OR
Press to leave the current unchanged.
VOL
1804:STA:nnn GRP:n
LINE GROUP n:nnn
You see the options for the next consecutive trunk group. The previ-
ously programmed value displays.
6. Enter Y to allow or N to prevent outgoing access to the trunk group selected +
VOL
OR
Press to select another trunk group.
CONF
OR
Press twice to select another extension.
CONF
OR
Press three times to exit the program.
CONF
System Programming
HOLD
DS1000/2000 Workbook
HOLD
143