NEC DS1000 Correspondence Course Workbook page 107

NEC America
DS1000/2000 Correspondence Course
Installing a Music Source
The CPU provides connection for a customer provided music source. Use
this music source for Background Music and Music on Hold.
To connect a music source:
1. Find an available connector in a station cable and make sure it is cor-
rectly punched down at the 66M1-50 block.
Follow standard color code order. Be sure the block is properly
cross-connected.
2. For the connector chosen, locate pins 2T and 2R (see figure below) and
connect the music source.
3. Plug the modular jack into the CPU modular connector.
Be sure the connected music source is compatible with the follow-
ing CPU music input specifications:
Input Impedance:
Output Level:
Programming Background Music:
0201: Background Music
Enter Y to enable Background Music system-wide.
1802: BGM
Enter Y to enable Background Music at the extension.
Programming Music on Hold:
0201: Music on Hold
Enter Y to enable Music on Hold system-wide.
0201: MOH on Transfer
Enter Y to enable Music on Hold for transferred calls.
The following products should help if you make your own cables:
Suttle SE-266-8K 8 Position Modular Plug (requires an SE-166 or
SE-166-6 modular crimping tool).
Hubbell BRFTP4P Snap-On 8 Position Modular Plug (does not
require a special crimping tool).
Check with your local supplier for other comparable products.
DS2000 System Installation
10K Ohms
+18 dBr (+/- 2 dBr) @ 1.0 kHz
DS1000/2000 Workbook 107