Setting The Dil Switches - Festo CPX-FB13 Electronic Manual

1. Installation

1.2.2 Setting the DIL switches

Festo P.BE−CPX−FB13−EN en 0308a
When the cover over the DIL switches is removed, you will see
3 DIL switches in the field bus node (see Fig. 1/3).
With these DIL switches you can set the following parameters:
the operating mode
the PROFIBUS address
the diagnostic mode.
Proceed as follows:
1. Switch off the power supply.
2. Remove the cover over the DIL switches
(see section 1.2.1).
3. Set the desired operating mode (DIL switch 1, factory
setting: Remote I/O).
4. Assign an unused station number to the CPX terminal.
Set the desired station number (8−element DIL switch 3,
switch elements 1...7).
5. Set the diagnostic mode (8−element DIL switch 3, switch
element 8).
6. Fit the cover (see section 1.2.1).
1−9