Pulse Fc Mode; Enable Pulse Fc Mode - Graco SDP8 Series Installation And Operation Manual

Pulse FC Mode

Pulse FC Mode
Pulse FC Mode is only available with the
purchase and installation of a Pulse FC
Starter Kit (P/N 26C401). The kit contains
everything needed to begin using Pulse FC
with the meter, including a programmer and a
software license.
Pulse FC uses NFC tags that are
programmed to initiate different functions on
the meter.
•
Profile tags and fluid totalizer tags can
program meter profiles and receive
actual dispensed totalizer values from
multiple meters.
•
Fluid dispense vouchers and calibration
vouchers can be used with only a single
meter before they must be
reprogrammed.
Tags may be purchased from Graco as packs
of cards. When a tag or voucher is referenced
in this manual, it refers to a card programmed
to perform the designated function.

Enable Pulse FC Mode

1. Press the center ENTER button on the
keypad to activate the meter, waking it
from sleep mode. The screen shown in
F . 55 displays.
IG
NOTE: The screen in FIG. 55 only
appears in Preset Mode the first time the
meter is powered on. After the first power
on, a meter in Preset Mode must be
RESET to get to this screen. See RESET
instructions, page 22.
F . 55
IG
28
2. Hold the profile tag to the display. When
the profile tag is valid, a CONFIGURING
(F . 56) message appears on the
IG
display.
NOTE: After the meter is placed in Pulse
FC mode, it will only accept vouchers
and tags configured by the same system
used to make the profile tag.
F . 56
IG
3. After the meter has been successfully
configured, the main menu screen
shown in F . 57 displays.
IG
F . 57
IG
3A6673B