Pulse And Sdp Trip Rod Replacement - Graco Pulse Series Repair Manual

Pulse and SDP Trip Rod
Replacement
Pulse and SDP Models use Trip Rod Repair
Kit 25D903
1. Follow Disassembly instructions, Steps
1 - 6, beginning on page 13.
2. Remove the batteries and turn metered
dispense valve over.
3. Remove 4 screws (21) and o-rings (20)
and carefully lift bezel (19) off housing
(12) (F . 23).
IG
NOTE: The solenoid and power will still
be connected to the bezel via the power
connections as shown in F
the bezel can be completely separated
from the housing, these connections
must be detached.
F . 23
IG
4. Disconnect the red and white solenoid
connection (a) (F
3A5413F
. 23. Before
IG
19
12
20
21
. 24).
IG
5. Disconnect the black and red power
connection (b) (F
NOTE: Be careful not to disturb the white
button board ribbon cable taped to the
bezel housing if reusing the bezel (19).
19
b
F . 24
IG
6. Loosen and remove solenoid (37) (F
25). The trip rod assembly (27) is located
below the solenoid.
F . 25
IG
Service
. 24).
IG
a
37
27
.
IG
15