Graco SDP8 Series Installation And Operation Manual page 32

Pulse FC Mode
D DISPENSED FLUID COUNTER- As fluid is
dispensed, this number increases to reflect
the quantity of fluid that is being dispensed.
E UNIT OF MEASURE - Pints, Quarts, Gal-
lons or Liters. Can only be set up by a Pulse
FC profile tag.
F PROGRESS BAR - Graphic representation
of the progression of the dispense shown by
gradually filling-in the empty space in the
bar. A textual representation of the progress
is also shown in a percentage format.
G PRESET AMOUNT - The volume of fluid
that the meter is currently authorized to dis-
pense. The value set by a Pulse FC fluid
voucher.
To dispense fluid:
1. Activate the meter. See Activation,
page 29.
2. If the meter recognizes the fluid voucher,
the DISPENSE screen shown in F
displays.
NOTE: All dispense parameters are
already set up including the unit of
measurement and the total amount of
fluid that can be dispensed. Adjustments
cannot be made to these parameters.
D
F
F . 68
IG
3. Squeeze the trigger to begin dispensing
fluid. A numeric volume of dispensed
fluid displays in field (D) and increases
while the fluid is dispensed.
32
The progress bar (F) fills-in and a
numeric percentage increases as the
amount of fluid dispensed nears the
Preset amount.
4. When the PRESET amount of fluid has
been dispensed the trigger deactivates,
stopping the fluid flow.
5. END is highlighted. Press the center
ENTER button on the key pad to end the
dispense. The Main Menu screen
displays.
END Function
During the dispense the word END (F
is highlighted on the lower left corner of the
dispense screen. To interrupt the fill during
dispensing:
1. Release the trigger and press the center
ENTER button on the key pad to select
END.
2. The dispense ends and immediately
. 68
IG
returns the meter to the MAIN MENU
screen. The dispense is complete.
NOTE: In Pulse FC Mode you continue
dispensing fluid to finish an interrupted
dispense.
. 68)
IG
3A6673B