Graco SDP8 Series Installation And Operation Manual page 20

Preset Mode
5. The screen shown in F
Notice the word "DONE" near the top of
the screen, confirming the requested
PRESET amount of fluid has been
dispensed. The progress bar (F) now is
entirely filled in and shows 100% of the
fluid requested has been dispensed and
the Dispensed Fluid Counter (D) now
shows 1.000 matching the chosen
PRESET parameters (K).
D
F
F . 33
IG
6. Use the LEFT ARROW on the keypad to
highlight RESET. Press the ENTER
button on the keypad to reset the meter
to 0.000 to prepare it for the next
dispense.
7. Use the RIGHT ARROW on the keypad
to highlight END. Press the center
ENTER button on the keypad to return to
the Main Menu Screen.
NOTE: If RESET was not selected after
the dispense was completed, the
amount of fluid dispensed in the last
dispense will be shown in this field. If
RESET was selected, the field will show
0.000.
20
. 33 displays.
IG
K
STOP Function
During the dispense the word STOP (F
is highlighted on the lower left corner of the
dispense screen. To interrupt the dispense at
any time during the fill:
1. Release the trigger and press the center
ENTER button on the key pad.
Notice the word "STOPPED" appears
across the top of the display (F
F . 34
IG
2. Use the LEFT or RIGHT ARROW button
on the keypad to highlight either:
•
END - Ends the dispense and
returns the meter to the MAIN
MENU screen.
•
PRESET - Allows for increasing,
decreasing or entirely changing the
amount of fluid for the PRESET
selection. The screen shown in F
31 displays. See Function
Command (C)/PRESET, page 18
for instructions on changing the
PRESET).
•
RESET - Resets the Dispensed
Fluid Counter (D) back to 0.000.
3. After making changes use the LEFT
ARROW button on the keypad to
highlight END. Press the center ENTER
button on the key pad to select END and
return to the Dispense screen to
complete the dispense.
. 32)
IG
. 34).
IG
.
IG
3A6673B