Installation - NEC Express5800/E120d-1 User Manual

Chapter 2 Preparations
1.8.3

Installation

Install a riser card to a PCI card in the following procedure.
1. Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Remove the screw securing the PCI riser
card. Hold the both ends of the PCI riser
card and lift it off.
3. Confirm the installation position with the reference to the table on 1.8.2 Supported boards and available
slots.
4. Remove the screw from the PCI riser card
and remove the blank cover.
5. Install a PCI card to the PCI riser card.
When installing the card, position the
terminal part of the PCI card to the PCI riser
card slot and insert it.
Important
When installing a PCI card, make sure the connector of the board fits the
connector of the riser card.
 If the battery for RAID controller is installed, refer to (1.8.6 Battery for RAID
Note
Controller).
Screw
Note
Keep the removed blank cover for future use.
Important
Do not touch the terminal part of riser card or PCI card and the signal pins
of electric parts installed on the board. Installing boards with dirt or oil can
cause malfunction.
 Make sure that the head of a PCI card bracket is seated into the fixed slot.
Note
 If you have trouble installing the card, remove the card once and try again. If you
apply excessive pressure on the card, a PCI card or riser card might break.
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices
PCI #1 side
PCI #2 side
63