NEC Express5800/E120d-1 User Manual page 104

Chapter 3 Setup
4. When the Off-line TOOL MENU appears, select BMC Configuration, BMC Configuration, Network,
and then Property.
5. If Property is selected, the following screen is displayed. On this screen, specify Enable if you want to
use DHCP, or specify IP Address/Subnet Mask if you do not use DHCP.
6. Connect the LAN cable to the management LAN connector in order to connect to the network. It will be
available for use if you access EXPRESSSCOPE Engine 3 via Web browser from PC for management
according to the setting.
104
Tips
If Shared BMC LAN is enabled, Web feature, remote media/KVM feature, or
command line interface feature may be interrupted. In this case, wait for a while,
and connect with network again.
Express5800/E120d-1 User's Guide
3. EXPRESSSCOPE Engine 3