Names And Functions Of Parts; Front View - NEC Express5800/E120d-1 User Manual

Chapter 1 General Description
4.

Names and Functions of Parts

This section describes the names of the server parts.
4.1

Front View

(6)
(1) POWER LED
This LED lights when Power is on. (See page 37.)
(2) Disk Access LED
This LED indicates status of internal hard disk drive.
(See page 39.).
(3) LINK/ACT LED
This LED turns on when the server is connected to the
network. (See page 39.)
(4) Unit ID (UID) LED
This LED turns on when UID Switch is pressed. Commands
from the software also cause it to turn on or flash.
(See page 39.)
(5) STATUS LED
This LED indicates the server status. (See page 38.)
(6) Display connector
Connect a display unit. (See page 91.)
(7) USB connectors
These connectors are used to connect devices that support
the USB interface. (See page 91.).
(8) BMC RESET Switch
The switch to reset BMC of this server. Use the switch only
when there is a problem with EXPRESSSCOPE Engine 3
(BMC).
To use this switch, press it at least five seconds.
(7) (1) (3)-1 (4)
(2) (3)-2 (5) (11)
(14)
(13)
(12)-0 (12)-1
(13)
Express5800/E120d-1 User's Guide
(8) (9)
(10)
(13)
(12)-2 (12)-4
(13) (12)-5
(12)-3
(9) Unit ID (UID) Switch
The switch to turn on and off UID LED.
Pressing the switch once turns on UID LED and pressing
again turns off the LED. (See page 48.)
(10) POWER Switch
The switch to turn the server on and off. Press once to turn
on the server. POWER LED lights when it is on. Press it
again to turn off the server. Hold down the switch for 4
seconds or longer to forcibly turn off the server.
(See page 95.)
(11) DUMP(NMI) Switch
When DUMP Switch is pressed, memory dump is
performed.
(12) Hard Disk Drive bay
The bay where HDD are installed. The sequential numbers
indicate the corresponding slot numbers. All bays include
Dummy Trays.
(13) DISK LED
The LED provided for each HDD.
This LED indicates hard disk drive status. (See page 40.)
(14) Pull-out Tab
A label indicating the part number and serial number of the
server is located on this tab.
4. Names and Functions of Parts
(12)-6
(13) (13)
(13)
(13) (12)-7
31