Removal / Replacement - NEC Express5800/E120d-1 User Manual
Hide thumbs
Also See for Express5800/E120d-1:
- Maintenance manual (150 pages) ,
- Update manual (4 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
1.7.5
Removal / Replacement
To remove DIMM, reverse the installation procedure.
Be sure to install dummy cover to the slots from where DIMMs are removed.
Take the steps below after replacing or removing DIMMs.
1.
Confirm that no error messages are displayed on POST. If any error message is displayed, refer to
Chapter 3 (1. Post Error Message) in "Maintenance Guide".
2.
Run BIOS Setup Utility, select Memory Configuration from the Advanced menu, and then specify Yes
for Memory Retest. After that, select Save Changes and Exit to reboot.
60
Note
When removing a defective DIMM, check error messages displayed at POST or
NEC ESMPRO and check the DIMM socket where the defective DIMM is installed.
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
