NEC Express5800/E120d-1 User Manual page 86

Chapter 2 Preparations
Installing outer rail
1. Attach the outer rail you previously
removed to the rack.
Fit the square-shaped protrusions of the
rail to the square holes of a 19-inch rack.
Make sure that it makes a clicking sound
indicating that it is locked.
The image on the right shows the front
right side (front) of the rack. Install to the
rear right side and front and rear left
sides following the same procedure.
Make sure that the rail assembly is
installed at the same height as the other
slide rail already installed.
Installing the Server
1. Pull out the sliding rails (bearing portion)
of the right and left rail assemblies toward
the front of the server.
2. Securely hold the server and install it in
the rack with at least two persons.
Firmly fit the inner rails on the sides of
the server into the rail assemblies that
are installed on the rack, and then slowly
push the server into the rack.
When the server is completely pushed
into the rack, the server is locked.
.
86
Important
Confirm that the rails are securely locked so that they will not fall off.
Tips
Although the rail assembly may be somewhat unsteady, it is not defective.
Important
Be very careful not to get your finger caught in the levers or rails.
Insert both sides of inner rails straight into the rack.
Express5800/E120d-1 User's Guide
2. Installation and Connection
Rail Assembly
Slide Rail
Rail Assembly
Inner Rail at server side