NEC Express5800/E120d-1 User Manual page 92

Hide thumbs Also See for Express5800/E120d-1:
Table of Contents

Advertisement

Chapter 2 Preparations
92
Tips
2 ports USB connectors at the rear of the server are supplied with power even
when DC is off.
 Turn off the server and peripheral devices to be connected before
Important
connecting. Connecting wit power ON can cause malfunction or failure.
 If connecting any peripheral device and its interface cable made by other
companies (a third party), contact the store where you purchased them to
check if they can be used with the server beforehand. Some devices from
a third party cannot be used with the server.
 Fix the power cord or interface cable with cable ties.
 Organize cables so that they will not contact the door of the rack or the
guide rails on the sides.
 When extending the server from the rack, disconnect the power cord and
interface cables.
 Make sure that no pressure is applied on the plug of power cord.
 Be sure to use the display unit specified by NEC. The operation is not
guaranteed if you install a display unit not specified by NEC.
Note
If you connect a card to a line, use the card which you have applied for with the
certification authority.
Tips
A leased line cannot be directly connected to the serial port connector.
Express5800/E120d-1 User's Guide
2. Installation and Connection
USB connectors at the rear

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nec express5800 series

Table of Contents