1.11.2 Removal - NEC Express5800/E120d-1 User Manual

Chapter 2 Preparations
6. Slowly close the handle.
The tray is locked making a clicking sound.
7. Turn on the server, run BIOS Setup Utility, and then specify the boot order from Boot menu.
For details, refer to Chapter 3 (2.BIOS Setup Utility (SETUP)).

1.11.2 Removal

To remove hard disk drive, reverse the installation procedure.
If you transfer or dispose of the removed hard disk drive, refer to Chapter 1 (1. Transfer, Movement, and
Disposal) in "Maintenance Guide" to erase data.
Turn on the server, start BIOS Setup Utility, and then specify the boot order from Boot menu.
For details, refer to Chapter 3 (2.BIOS Setup Utility (SETUP)).
80
Note
When you push the drive into the slot, confirm the handle got hooked on the
frame.
Tips
The saved boot order is cleared when a hard disk drive is added.
Important
NEC assumes no liability for data leakage should the product be
transferred to a third party without erasing the data.
Note
If you must remove a hard disk drive due to a failure, check the slot with its DISK
LED lit in amber.
Note
Do not pull the slot out from the handle. Doing so may damage the handle.
Tips
The saved boot order is cleared when a hard disk drive is added.
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices
DISK LED