Chapter 2 Preparations
Take the following procedure to install RAID Controller (N8103-152).
1.
Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove the two screws and remove PCI
Riser Card.
3.
Remove the screw securing the PCI riser
card. Hold the both ends of the PCI riser
card and lift it off.
4.
Remove the screw from the PCI riser
card and remove the blank cover.
5.
Fix on the Riser Card with screw you
removed at step 4.
68
Screw
Note
Keep the removed blank cover for future use.
Express5800/E120d-1 User's Guide
1. Installing Internal Optional Devices
Bracket for Low profile
PCI #1 side
Bracket for full hight
PCI #2 side