Introduction; Overview - Siemens SIMATIC Ident Function Manual

Introduction

1.1

Overview

FB 45 is a STEP 7 function for RFID technology. It can be used with both the SIMATIC S7-
300 and S7-400 for various RFID communications modules.
Figure 1-1
The section "Brief description of the hardware" in the Appendix illustrates configurations with
the various communications modules. FB 45 can be operated in various different
configurations:
● The CM is operated directly in a SIMATIC S7-300.
● The communications module is located in the rack of an ET 200M or ET 200pro. The
● The CM is a self-contained PROFIBUS slave and is connected to the integrated
● The CM can be operated both via PROFIBUS or PROFINET.
● The CM is operated on PROFINET via the IE/PB Link.
These configurations can be mixed and different communications modules can also be
connected.
Assign parameters for the RF600 reader with FB 45
A separate manual is available for the parameter assignment of the RF620R/RF630R
readers. In the "Configuration Manual RF620R/RF630R
(http://support.automation.siemens.com/WW/view/en/33287195)" manual, you will find all the
important information about commissioning, parameter assignment, error messages and
how to handle errors/faults as well as many examples and applications for using the RF600.
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
Communications modules for FB 45
ET 200M/ET 200pro is used with an S7-300 or S7-400.
PROFIBUS connector of a SIMATIC S7-300 or S7-400.
1
5