Siemens SIMATIC Ident Function Manual page 24

Parameterizing
3.1 Parameter data block
Variable
field_ON_control
MOBY D, RF200 and RF300:
00 hex (reserved)
MOBY U:
BERO mode; automatic activation/deactivation of the antenna field. The "Antenna ON/OFF"
command is superimposed by the BERO mode.
field_ON_time (ftim) RF200:
Value
RF300:
With the aid of the "ftim" parameter, a decision is made whether the reader is operated in RF300
mode or in ISO 15693 mode (mixed operation is not intended).
The following values can be set:
Value
24
00 hex = without BEROs; no write/read device synchronization
01 hex = one or two BEROs
The BEROs are combined according to logic OR. The field is ON during
actuation of a BERO.
02 hex = One or two BEROs
The 1st BERO switches the field on and the 2nd BERO switches the field off.
If two BEROs exist and a field_ON_time is set, the field is automatically
deactivated if the 2nd BERO does not switch within this BERO time.
If no field_ON_time is set, the field remains on until the 2nd BERO is
actuated.
03 hex = Activate write/read device synchronization via cable connection (see manual
for configuring, mounting and service for MOBY U)
Transponder type
01 Any ISO tag
Transponder type
00 RF300
01 Any ISO tag
03 ISO my-d (Infineon SRF 55V10P)
04 ISO (Fujitsu MB89R118)
05 ISO I-Code SLI (NXP SL2 ICS20)
06 ISO Tag-it HFI (Texas Instruments)
07 ISO (ST LRI2K)
Description
Comment
-
Comment
To be used for all transponders of the type
RF3xxT
Activation of the general ISO mode with
rudimentary ISO commands. With this
setting, operation is basically guaranteed
with every ISO-compatible tag.
e.g. MDS D324, D339
e.g. MDS D421, D422, D423, D424, D425,
D426, D428, D460,
e.g. MDS D100, D124, D126, D139, D150,
D165
e.g. MDS D200 (order no. 6GGT2600-
1AA00-0AX0), D261
e.g. MDS D200(order no. 6GGT2600-
1AA01-0AX0), D261
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618