Siemens SIMATIC Ident Function Manual page 20

Parameterizing
3.1 Parameter data block
Address Name
+18.5 battery_low
+18.6 error
+18.7 ready
+19.0 cancel
+19.1 command_start
+19.2 repeat_command
+19.3 init_run
+19.4 ASM_failure
+19.5 FB45_active
+19.6 ANZ_next
+19.7 ANZ_reset
+20.0 ASM_busy
+20.1 command_rep_active
+21.0 number_MDS
+22.0 error_MOBY
+23.0 error_FB
+24.0 error_BUS
+26.0 version_MOBY
+28.0 counter_customer
*4.0
+44.0 initRUN_timeout
+46.0 PEW_timeout_ASM_fail
+47.0 PEW_timeout
+48.0 reserved3
+49.0 Testbyte
=50.0
*) Parameter data block UDT 60 is available for transponders > 32 KB. The data type here is WORD.
**) RF300, reader only: 6GT2801-3AB10
*** ) RF300 reader in ISO mode
20
Type Initial value
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL TRUE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BYTE B#16#0
BYTE B#16#0
BYTE B#16#0
WORD W#16#0
WORD W#16#0
BYTE B#16#2
DWORD
INT 1000
BYTE B#16#5
BYTE B#16#32
BYTE B#16#0
BYTE B#16#0
END_STRUCT
Comment
Battery check has indicated low
voltage
Error during command execution
Command chain has been finished.
Set: abort command or command chain
Set: start signal for command or
command chain
Set: repeat last command
Set: reset CM and set new parameters
OB122 Set: CM failed
FB active
NEXT command was last command
Init_run was last command
CM processes a command
CM repeats command
Number of tags actually in field
Error indicated by CM
Error indication of FB
Error indicated for PROFIBUS/PROFINET
Firmware version CM
Setting for S7 cycles per command
execution
FB-internal variables. You should not
attempt to modify these variables.
FB-internal variables. You should not
attempt to modify these variables.
FB-internal variables. You should not
attempt to modify these variables.
FB-internal variables. You should not
attempt to modify these variables.
FB-internal variables. You should not
attempt to modify these variables.
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618