Siemens SIMATIC Ident Function Manual page 118

Programming communications modules
B.5 PROFIBUS/PROFINET implementation
Table B- 1
Data record
Data record 10x
One RFID channel is assigned parameters with the data records (DS) 101 to 104. DR 10x
must contain a RESET command. After the module starts up, DS 10x must be sent to each
RFID channel. The channel is not ready for operation until this is done.
A DR 10x is also accepted during normal operation. DS 10x interrupts a running command.
The user receives no further acknowledgment for the interrupted command.
Data record 11x
DRs 111 to 114 are used for sending the actual commands and related acknowledgments
(all commands except RESET).
118
Data record numbers (index)
number
101 all
all
102
103 -
104 -
111 all
112 all
113 -
-
114
121 ASM 456, RF160C, (RF170C),
RF180C
122 ASM 456, RF160C, (RF170C),
RF180C
150 ASM 475
151 ASM 475
180 RF180C
231 RF170C
232 RF170C
233 RF170C
234 RF170C
ASM 456, ASM 475, RF160C,
239
RF170C, RF180C
246 ASM 475
247 (ASM 456, RF160C)
248 ASM 475, RF170C, (ASM 456,
RF160C)
255 ASM 456, RF160C
Exist on
CM/reader
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
Description
Parameter assignment channel 1
Parameter assignment channel 2
Parameter assignment channel 3
Parameter assignment channel 4
Data transmission channel 1
Data transmission channel 2
Data transmission channel 3
Data transmission channel 4
System command to reader
(in preparation for RF170C)
System command to reader
(in preparation for RF170C)
Reserved (diagnosis of powerparameters)
Reserved (diagnostic buffer)
reserved
I&M0
I&M1
I&M2
I&M3
Firmware update
SSL reserved
SSL reserved
System: SSL processing I&A
I&M PROFIBUS
FB 45 for MOBY U, MOBY D, RF200, RF300