Siemens SIMATIC Ident Function Manual page 7

PROFIBUS configuration
A GSD file is available on the "RFID Systems Software & Documentation" DVD
(6GT2080-2AA20) for the communications modules that can be connected directly to
PROFIBUS.
PROFINET configuration
A GSDML file is available on the "RFID Systems Software & Documentation" DVD
(6GT2080-2AA20) for the communications modules that can be connected directly to
PROFINET.
Non-SIMATIC applications
Applications programmed on third-party controllers cannot use FB 45.
When programming the third-party controller, keep to the standard IEC 61131:
● The third-party controller can be programmed according to IEC 61131:
● The third-party controller cannot be programmed according to IEC 61131:
Requirements for using FB 45
FB 45 can access the communications module via any PROFIBUS/PROFINET master that
has the system function blocks SFB 52/53. It is irrelevant whether the
PROFIBUS/PROFINET master is integrated in the S7-CPU or plugged into the rack as an
add-on module (e.g. IM 467).
Please note that FB 45 uses acyclic frames (SFB 52/53). Older CPUs of the SIMATIC family
or small model series may not have these services. Please check this during configuration.
● STEP 7 version
● TIA Portal
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
Use the function block RFID standard profile. You will find the source code to match the
block on the DVD "RFID Systems, Software & Documentation" (6GT2080-2AA20). You
can compile the source code into the machine code of the target system. You will also
find the documentation for this on the DVD.
The relevant interface is described in the section "Programming the communication
modules on PROFIBUS/PROFINET (Page 99)" of this manual. Programmers of a third-
party controller can use this interface to develop their own RFID function. The same or
similar data structures as in FB 45 can be reproduced on a third-party PLC in conjunction
with FB 45 description and the UDTs.
The ASM 475 module requires a STEP 7 version ≥ V 5.1.
Introduction
1.1 Overview
7