Siemens SIMATIC Ident Function Manual page 48

Error messages and troubleshooting
5.2 Error messages
NOTICE
When several error occur with chained commands, the "error variable" always indicates the
first error detected.
error_MOBY
The ERR LED of the reader flashes when there are error messages. Some errors are also
indicated by the flashing ERR LED of the CM.
Table 5- 2
Error code
(B#16#...)
48
Error messages of the communication module/reader using the "error_MOBY" variable
Flashing of
ERR LED
00 – No error
Default value if everything is ok.
– 1x No error
CM has started up and is waiting for an init_run.
01 2x Presence error: The tag has moved out of the transmission window of
the reader. The command was executed only partially.
Read command: No data are transmitted to FB 45.
Write command: The tag that has just left the field contains an
incomplete data record.
•
•
The next command is automatically executed on the next tag. A
read/write command is possible.
02 2x Presence error: A tag has passed by a reader without being processed
by a command.
This error message is not reported immediately. Instead, the CM is
waiting for the next command (read, write). This command is
immediately replied to with this error. This means that a read or write
command is not processed. Only the next command is executed
normally by the ASM again.
An init_run from FB 45 also resets this error state.
The operating distance from reader to tag is not being kept to.
Configuration error: The data record to be processed is too large (in
dynamic mode)
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
Description
FB 45 for MOBY U, MOBY D, RF200, RF300