Programming - GSS HDMT 1000 MPTS Assembly Instructions Manual

• By pressing
If the input signal path "A+B+ASI=1 ASI=2" is selected the station filter of
channel strip "B" is used in the channel strip "A". Therefore perform the set-
tings for channel strip "B" according to the pages 30 ... 32 (Setting the input
channel, Setting the hierarchical modulation) before activating the "Setting the
station filter" – "PROGRAM" menu.
If the input signal path "A+ASI=1 B+ASI=2" or "A+ASI=1 A+ASI=2" is se-
lected the channel strips can be programmed one after the other.
• Press the
s
tat i o n
The default setting for the station filter is "off". In this menu you define the
services received to be transmitted. If services are activated the output data
rate increases.
If the station filter is switched off (factory default) all services of the transport
stream passes the station filter.
The figure of the menu below is dependent on the setting of the "Input signal
path" "INROUTE" menu (page 24).
The programming procedure shown below corresponds to the setting
"A+B+ASI = 1 ASI = 2".
With this setting the transport stream of channel strip "B" is routed to the trans-
port stream of channel strip "A" and therefore cannot be set in channel strip
"B". Programming channel strip "B" the transport stream coming from the ASI
input can be processed only.
set to "high" or "low".
—> Not relevant in the case of standard modulation.
button.
—> The "Station filter" – "PROGRAM" menu is activated.
f i lt e r
- 31 - HDMT 1000 MPTS