GSS HDMT 1000 MPTS Assembly Instructions Manual page 29

l an
data
In this menu you adjust the LAN output data rate.
• Press the
rate to be set.
• Using the
"auto").
• Press the
i
n P u t
Once the RF receiving stage has synchronised to the input signal, "OK" is
displayed.
If "– –" appears in the second line of the display, there is no input signal
present. Check the configuration of the antenna system and the head-end sta-
tion as well as the preceding settings of the cassette.
• Use the
"C21" ... "C69").
• If necessary use the
r at e
buttons to position the cursor under the digit of the data
buttons set the desired data rate (2 MBit... 80 MBit,
—> The sum of the data rates of the lines A + B must not exceed 80 MBit
button.
—> The "Input channel" – "INPUT" menu is activated.
C h a n n e l
buttons to set the desired input channel ("C5" ..."C12",
—> Beside the input channel set the relevant input frequency is dis-
played.
—> "0" is displayed instead of the frequency display.
Bx 4A LAN RATE
auto
Bx 4A INPUT
C30 (546.0) OK
button to activate the menu item "Fine tuning".
- 29 - HDMT 1000 MPTS