Resistance Measurement And Continuity Test - HT ECLIPSE HT9025 User Manual

5.5.

RESISTANCE MEASUREMENT AND CONTINUITY TEST

Before attempting any resistance measurement, cut off power supply from
the circuit to be measured and make sure that all capacitors are discharged,
if present.
Fig. 27: Use of the instrument for resistance measurement and continuity test
1. Select position
2. Insert the red cable into input terminal VHz% CAP
input terminal COM.
3. Position the test leads in the desired spots of the circuit to be measured (see Fig. 27).
The display shows the value of resistance.
4. If the display shows message
5. Press the MODE/VFD key to select
and position the test leads in the desired spots of the circuit to be measured.
6. The value of resistance (which is only indicative) is displayed in
sounds if the value of resistance is <50.
7. To use the HOLD and RANGE functions, see § 4.2
8. To use the internal functions, see § 4.3
9. To save the measured result, see § 4.3.4
CAP
OL , select a higher range.
" "
" "
EN - 25
CAUTION
measurement, relevant to the continuity test,
ECLIPSE - HT9025
and the black cable into
and the instrument