Installing The Lens - Christie CP2308-G Installation And Setup Manual

A Mounting arm
B Ball joint
4. Tighten the mounting arm until it fits tightly on the ball joint.
5. Connect the touch panel harness to the touch panel:
a) Connect one end of the USB cable to the USB port on the rear of the touch panel.
b) Connect one end of the touch panel power cable to the DC IN 12V port on the rear of the
touch panel.
c) Connect one end of the VGA connector to the VGA port on the rear of the touch panel.
6. Connect the touch panel harness to the projector:
a) Connect the other end of the USB cable to a USB port on the projector communications
panel.
b) Connect the other end of the touch panel power cable to the Screen Power port on the
projector communications panel.
c) Connect the other end of the VGA connector to the VGA Out port on the projector
communications panel.
7. To turn the touch panel on, press the power button on the top of the panel.
If the projector is not connected to AC power, you cannot turn the touch panel on.

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off and unplug the projector.
CP2308-G Installation and Setup Guide
020-102866-01 Rev. 1 (05-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
16