Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. Remove the lens surround.
2. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
3. Insert the lens straight into the lens mount opening without turning.
Magnets inside the lens mount help position the lens.
4. Insert and tighten the two lens mount hex screws shipped separately with the projector.
5. Lock the lens assembly in place with a hex key.
6. Replace the lens surround.
CP2308-G Installation and Setup Guide
020-102866-01 Rev. 1 (05-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
17