Table of Contents
Advertisement
Installation and setup
Learn how to install, connect, and optimize the projector.
This section provides detailed information on projector setup.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
1. Position each person at the corners of the projector.
2. Lift up the projector and move it to the location where it will be used.
3. Position the projector so it is centered and parallel with the theater screen. If space is limited,
aim the projector slightly off-center and use lens offset to center the image on the screen.
Adjusting tilt and leveling the projector
To ensure optimum performance, install the projector so it is centered and parallel with the screen.
To compensate for tilt or offset, you can adjust the projector feet and the lens mount position.
The front-to-back tilt of the projector must not exceed 15°.
1. To adjust the height of the projector, loosen the lock nut on the adjustable feet on the bottom
of the projector.
A
19 mm (0.75 in.) wrench
CP2308-G Installation and Setup Guide
020-102866-01 Rev. 1 (05-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
11
Advertisement
Table of Contents
