Safety Machine Accessories; Total Stop; Arm Covers - Bomar Individual Automatic Series Operating Instructions Manual

Do not remove or do not lock the limit switches or safety equipments! Any use of the
saw, accessories or machine parts other than that intended by the BOMAR, spol. s r.o.
company is not permitted. The guarantee on this product will be afterward lost and
BOMAR, spol. s r.o. takes no responsibility for caused damages.
1.5.

Safety machine accessories

The machine is equipped with safety accessories. It protects the operator from injuries
and the machine before damage. The safety accessories are blocking accessories,
emergency switches and covers. Check once in a week the function of the safety
accessories. If the safety accessories are functionless, you must stop work and repair or
change the safety accessories.
Enhanced risk!
Do not come into or intervene in the cutting area. Otherwise,
there is possibility of heavy injury.
1.5.1.

Total Stop

TOTAL STOP button is used for emergency switching – off the machine in case defect
or health hazard. By pressing TOTAL STOP button is interrupted the supply of the
electrical power.
If any damages or fault appears, immediately press TOTAL STOP button!
After push TOTAL STOP button is shown warning message on LCD.
Release the pressing button is possible by twisting of the upper part of the button.
1.5.2.

Arm covers

Left cover – It covers tightening wheel. If the cover is opened during operation, the
limit switch is opened and the band saw is stopped. The band saw is not possible start
in set mode.
Right cover – It covers driving wheel. If the cover is opened during operation, the limit
switch is opened and the band saw is stopped. The band saw is not possible start in set
mode.
Central cover – It covers band saw.
The band saw is stated to the operation, when the covers is closed!
11