Regulation of pressure into cut
7
Regulation valve sets pressure into cut.
Regulation valve
Regulation valve sets the lowering speed of the frame into the cut. The speed is limited by the adjustment
8
of the pressure regulation in the cut on the guiding cubes.
Note: If the throttle valve is closed too tightly, the valve seat may be damaged and may start to leak. Tighten the
valve lightly.
Frequency changer
9
Turn to change to speed of the saw band.
Safety circuit
10
Press button to start the safety circuit
Machine mode selection
•
1 – Adjustment mode
11
•
2 – Machine operation mode
•
0 – Machine setting mode
STOP button
Interrupts the cycle, to restart press 8 – START button.
12
START button
Press to start the work cycle. Press 8 – STOP to stop the cycle.
3.3.
Service parameters
Attention!
Wrong setting of following parameters may damage the
machine. Change the values reasonably!
Enter the service parameters menu
Turn the key switch into position 0
1.
Select the item Service parameters on LCD
2.
To leave the menu:
•
Turn the key switch to different position
3.
•
Press
3.3.1.
Service parameters 1
1
2
3
4
:
button
5
6
7
33