Button
The active field in the program list is displayed in red.
Two values are set for each program:
•
Length of individual pieces
•
Number of individual pieces
3.5.2.
Automatic cycle
To enter the automatic cycle:
Turn the key switch into position 2 – Working mode
1.
Select the item Automat with feed on LCD
2.
The menu to enter the new values for automatic cycle or menu allowing
3.
proceeding with started automatic mode follows.
Preparation before start of the automatic mode:
This menu allows entering the start program and parameters adjusting the automatic
mode.
Select the menu item Presets to enter the Cutting mode, see previous chapter Cutting
modes.
Description
To move any program to different position in the list.
To enter the program to a new place in the list.
To edit the values of the program.
To remove any program (reset the values).
39