Brush Replacement - Bomar Individual Automatic Series Operating Instructions Manual

7. From both hardmetal guides screw out worn hardmetals and change them with
new ones.
8. Both hardmetals guides incl. press springs mount back. With 3 screws and aux. saw
band setup optimal play between guides.
4.7.4.

Brush replacement

If the chip removing brush is not able to fulfil its function, it has to be replaced.
1. Hold shaft of the brush by wrench.
2. Release the nut on the brush, replace worn brush on the new brush, screw on the
nut.
3. Set the brush to the saw band.
63