Table of Contents
Advertisement
3.7.6.
3.7.7.
46
1.
Release the fastening lever.
2.
Swivel the frame to the desired angle by pulling the saw arm. Angle is shown on
scale
3.
After cutting angle setup tighten securing lever.
Electronic measuring and display of the cutting angle is
optional accessory and is not standard part of the machine.
Attention!
Moving parts of the vice must be moved when saw arm has zero
angle of rotation and closed vice jaws.
Moving vice jaw of vice must be in endmost position otherwise
there is a danger of collision saw arm with vice.
Electronic admeasurement (252.178/252.177) – optional acessories:
Desired cutting angle is shown on LCD. How to use electronic admeasurement is
described in special instruction manual.
Setting of the cutting speed
The speed of the saw band can be gradually adjusted from 20 to 120 m.min
speed as follows:
•
Set the switch of the frequency changer 7 to required speed. The band speed is
displayed during semiautomatic cycle (one cycle automatic).
Frame bottom stop position setting
The bottom stop position of the frame limits the lowest position of the frame. This
position must be checked once per month. In case of wrong setting the vice may be
cut or the material is not cut completely.
-1
. Set the
Manual version:
1.10 / Jan. 2011
Manual rev.:
1
Advertisement
Table of Contents
