GE Lullaby Warmer Maintenance And Service Manual page 107

9C. Remove the plug button and then disconnect the red color harness by unscrewing the
screw.
9D. Disconnect the green-yellow harness by unscrewing the nut, then unscrew all the three
plastic clamps to completely disconnect the blue harness.
Note: All removed fasteners and the three plastic clamps are reusable (not to discard).
Caution: - Discard the old cable harness assembly completely to avoid mix up before you
assemble the new part.
Instructions to replace the Heater Assembly and cables.
1. Insert the new heater assembly from the front end of the hood.
Note: Ensure that the observation lamp face the rear bracket when the heater assembly is
Lullaby Warmer
TM
Plastic clamp
Unscrewing green-yellow
harness
2042376-001 Rev G ©2012 General Electric Company. All rights reserved. 81
9C
9D
Removed old
harness
assembly