Figure 61: Printed Circuit Board Wire Assembly (Pwa) - GE Lullaby Warmer Maintenance And Service Manual

NOTE: For Warmer with halogen lamp and
transformer.
NOTE: For Warmer with SMPS and LED
observation lamp.
Figure 61: Printed Circuit Board
Wire Assembly (PWA)
48 2042376-001 Rev G ©2012 General Electric Company. All rights reserved. Lullaby
NOTE: First tighten the M5 screws and then
the M8 x 25 csk screws.
5. Refer to Figure 61. On the PWA (PCB
Wire Assembly) fix the connector from:

Observation lamp plug 'P13' to 'J13'
connector on PWA.

Heater cable plugs 'P10' to 'J10' on
PWA.

Heater earth G4 to be screwed as
shown in Figure 61.

Swivel sensor switch 'P6' to'J6' on
PWA.
NOTE: For a detailed figure, please refer
section 7.1.6.
Warmer
TM