Figure 53: Leg Assembly - GE Lullaby Warmer Maintenance And Service Manual

Figure 53: Leg Assembly

Lullaby Warmer
TM
2042376-001 Rev G ©2012 General Electric Company. All rights reserved. 41
2. Apply brakes on the rear castors.
3. On the pillar assembly, remove
the front and the rear skirts using
3mm hex key.
4. Slide the pillar assembly over the
leg assembly through the base 'C'
support.
5. Use the handle or fulcrum to lift
the base assembly to the desired
height.
Note: To fix the warmer bed at the desired
height, align the holes as described in
the procedure to adjust the height of
the warmer bed.
6. Align the holes on the pillar
assembly with the holes on the
leg assembly.
7. Insert the height adjustment pin
into the height pin guide.