Default Attribute Time - ETC Cobalt Series User Manual

If the FCB Times are set to 50% of the IN-time they will be 2.5 seconds at an in time of 5 seconds.
If the In-time is changed to 10 seconds, the FCB-times will be 50% of 10 (= 5 seconds).
NOTE
In Congo plays files earlier than Version 4.2, the FCB Delay time was set to
100% due to the fact that Delay Times were inherited from the Delay In
time. These plays (pre-4.2) with FCB Delays set to 100% will be converted to
use a delay of 0s instead.

Default Attribute Time

The Default Attribute Time (3 seconds) is used mainly to keep noise and unnecessary mechanical
friction down when a Moving Device is positioned in the following situations:
•
When attributes are executed from Independents
•
When copying Blind attributes to Live
•
When using Stop table for an old dynamic
•
When you press Home Attributes
•
When jumping in the sequence
•
Using REFRESH in the Main Playback
642
Cobalt 8.1 - 20181029