Trane Tracer UC600 Installation Manual page 34

O O b b j j e e c c t t a a n n d d D D i i a a g g n n o o s s t t i i c c D D a a t t a a P P o o i i n n t t s s
Table 9. All Object Types Sorted by Object Name (continued)
Object
Object Name
Identifi-
er
Compressor 2
BV200
Calculated Status
Compressor 2
AV322
Calculated Superheat
Compressor 2 Call
BV201
Compressor 2
BO12
Command
Compressor 2 Cond
BV203
Purge Status
Compressor 2 Cond
BV204
Valve Open
Compressor 2
AO82 Condenser Regulating
Valve
Compressor 2
AI96 Discharge Pressure
Sensor
Compressor 2
Estimated Cond
AV323
Approach Temp
Compressor 2
Estimated Evap
AV324
Approach Temp
Compressor 2 Failure
BV205
Reset
Compressor 2 High
BI91
Pressure Cutout
Compressor 2 Lockout
BV30
BAS
Compressor 2 Max
AV325
Cond Valve Setpoint
Compressor 2 Min
AV326
Cond Valve Setpoint
Compressor 2 Mode
MV71
Compressor 2 Run
BV206
Hour Reset
Compressor 2 Run
AV327
Hours
Compressor 2 Safety
BI107
Circuit Status
Compressor 2 Safety
BV207
Lockout
Compressor 2
AV328
Sequence Number
34
Units of Minimum
Measure Maximum
None None
Temperature -50°C (-58°F) to
(°C or °F) 236°C (482°F)
None None
None None
None None
None None
0% to 100%
Percent
Open
Pressure
0 to 750 PSI
(PSI)
Temperature -50°C (-58°F) to
(°C or °F)
236°C (482°F)
Temperature -50°C (-58°F) to
(°C or °F) 236°C (482°F)
None None
None None
None None
Percent -150% to 150%
Percent -150% to 150%
None None
None None
0 -
None
9999999827968
None None
None None
None 0 - 5
When the Object
Exists
Units with 1
Compressor
Calculated Superheat of the Suction
Units with 2
line by Temperautre and pressure
Compressor
Units with 1
Compressor
Normally Open Contacts Used Only
Units with at least 2
Open = Stop Closed = Run
Compressors
Normally Closed Contacts not used
Units with 1
Compressor Closed = Purge Active
Units with 1
Compressor
Unit that Circuit 2
Analog Control that regulates water
has a Water
throught the water cooled condenser
Regulating Valve
installed
Units with at least 2 Local Compressor Refrigerant
Compressors Discharge (High) Pressure Sensor
Units with 2 Calculated Condenser approach
Compressor with temperature based off Refrigerant PT
Cond Reg Valve Conversion and water temperature.
Calculated approach temperuatre of
Units with 2
the Evaporator refrigerant temprature
Compressor
and the air temperature.
Units with 1
Compressor
Normally Closed Input
Units with at least 2
Compressors
Units with at least 2
Compressors
Closed = Locked Out
Units with 2
Maximum Valve position for the
Compressor with
condenser regulating valve.
Cond Reg Valve
Units with 2
Maximum Valve position for the
Compressor with
condenser regulating valve.
Cond Reg Valve
[4, Diag: Safety Circuit Alarm]
[5, Diag: Low Superheat]
[6, Diag: Suction Press Sensor Failure]
[7, Diag: Suction Temp Sensor
Units with at least 2 [8, Diag: Frostat Aarm]
Compressors [9, Diag: Discharge Press Sensor
[10, Diag: High Pressure Cutout
[12, Diag: High Superheat]
[13, Warn: High Disc Press]
[14, Comp Locked Out]
[15, Warn: Frostat Warning]
Units with 1
Compressor
Totalized run hours of the compressor
Units with 2
from the last run hour reset or
Compressor
Normally Open Input
Units with at least 2
Open = Circuit Open
Compressors
Closed = Circuit Closed (Completed)
Units with 1
Compressor
Closed = Lockout Active
Units with 2 Sequence Number to indicate what
Compressor sequence the compressor will start in.
Description
Open = Off
Closed = On
sensors.
Open = Stop
Closed = Run
Open = Inactive
Open = Closed
Closed = Open
of the compressor
Open = Normal
Closed = Reset
Open = Alarm
Closed = Normal
Open = Available
[1, Off]
[2, Starting]
[3, Running]
Failure]
Failure]
Alarm]
[11, VFD Fault]
Open = Normal
Closed = Reset
program change.
Open = Inactive
BAS-SVP042A-EN
Read/
Write
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only