Trane Tracer UC600 Installation Manual page 33

Table 9. All Object Types Sorted by Object Name (continued)
Object
Object Name
Identifi-
er
Compressor 1 Max
AV308
Cond Valve Setpoint
Compressor 1 Max
AV309
Speed (RPM)
Compressor 1 Max
AV310
Speed Setpt (RPM)
Compressor 1 Min
AV311
Cond Valve Setpoint
Compressor 1 Min
AV312
Speed (RPM)
Compressor 1 Min
AV313
Speed Setpt (RPM)
Compressor 1 Mode
MV70
Compressor 1 Run
BV196
Hour Reset
Compressor 1 Run
AV314
Hours
Compressor 1 Safety
BV197
Lockout
Compressor 1 Status
BI114
Compressor 1 Suction
AI94
Pressure Sensor
Compressor 1 Suction
AI95
Temperature
Compressor 1 Variable
AO90
Speed Command
Compressor 1 VFD
BO108
Alarm Reset
Compressor 1 VFD
BI98
Fault
Compressor 2
Calculated Diff
AV319
Refrigerant Pressure
Compressor 2
Calculated Saturated
AV320
Discharge Temp
Compressor 2
Calculated Saturated
AV321
Suction Temp
BAS-SVP042A-EN
Units of Minimum
Measure Maximum
Percent -150% to 150%
5500 -15000
None
RPM
5500 -15000
None
RPM
Percent -150% to 150%
1100 -15000
None
RPM
None 1200 - 4000 RPM
None None
None None
0 -
None
9999999827968
None None
None None
Pressure
0 to 750 PSI
(PSI)
Temperature
-50°C (-58°F) to
(°C or °F) 236°C (482°F)
0% to 100%
Percent
Speed
None None
None None
-500 psi to 500
PSI
psi
Temperature -50°C (-58°F) to
(°C or °F) 236°C (482°F)
Temperature -50°C (-58°F) to
(°C or °F)
236°C (482°F)
O O b b j j e e c c t t a a n n d d D D i i a a g g n n o o s s t t i i c c D D a a t t a a P P o o i i n n t t s s
When the Object
Exists
Units with 1
Maximum Valve position for the
Compressor with
condenser regulating valve.
Cond Reg Valve
Units with 1 Maximum Speed for the installed
Compressor Compressor (Set at Factory)
Maximum Speed Setpoint for the
Units with 1 installed compressor. (May not be the
Compressor compressor maximum and set at
Units with 1
Maximum Valve position for the
Compressor with
condenser regulating valve.
Cond Reg Valve
Units with 1
Maximum Speed for the installed
Compressor Compressor. (Set at Factory)
Maximum Speed Setpoint for the
Units with 1 installed compressor. (May not be the
Compressor compressor maximum and set at
[4, Diag: Safety Circuit Alarm]
[5, Diag: Low Superheat]
[6, Diag: Suction Press Sensor Failure]
[7, Diag: Suction Temp Sensor
[8, Diag: Frostat Aarm]
Units with at least 1
[9, Diag: Discharge Press Sensor
Compressor
[10, Diag: High Pressure Cutout
[12, Diag: High Superheat]
[13, Warn: Cond Limit Active]
[14, Comp Locked Out]
[15, Warn: Frostat Limit Active]
Units with 1
Compressor
Totalized run hours of the compressor
Units with 1
from the last run hour reset or
Compressor
Units with 1
Compressor
Closed = Lockout Active
Unit where
Normally Open Input
compressor 1 is a
VFD Compressor
Units with at least 1 Local Compressor Refrigerant Suction
Compressor (Low) Pressure Sensor
Units with at least 1 Local Compressor Refrigerant Suction
Compressor (Low) Temperature Sensor
Unit where
Analog signal that controls the
compressor 1 is a
VFD Compressor
Unit where Normally Open Contacts Used Only
compressor 1 is a Open = Normal Closed = Reset
VFD Compressor Normally Closed Contacts not used
Normally Closed Input
Units with at least 1
Compressor
Calculated Differential Pressure
Units with 2
between the Discharge and Suction
Compressor
Calculated Saturated Discharge
Units with 2
Temperature calcualted by the
Compressor
refrigerant temp and pressure.
Units with 2 Calculated Suction Temperature by
Compressor pressure to temperature conversion.
Description
Factory)
factory)
[1, Off]
[2, Starting]
[3, Running]
Failure]
Failure]
Alarm]
[11, VFD Fault]
_x000D_
Open = Normal
Closed = Reset
program change.
Open = Inactive
Open = Off
Closed = On
compressor speed
Open = Alarm
Closed = Normal
Pressure Sensors
Read/
Write
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
33