Trane Tracer UC600 Installation Manual page 30

O O b b j j e e c c t t a a n n d d D D i i a a g g n n o o s s t t i i c c D D a a t t a a P P o o i i n n t t s s
Table 8. Multi-state Values (continued)
Object
Object Name
Identifi-
er
DX Staging Status
MV42
Compressor 1 Mode
MV70
Compressor 2 Mode
MV71
Compressor 3 Mode
MV72
30
Units of Minimum
Measure Maximum
None None
None None
None None
None None
When the Object
Exists
[2, Start Interval Active]
All Units
[3, Shutdown Delay Active]
[4, Subtract Suspended]
[4, Diag: Safety Circuit Alarm]
[5, Diag: Low Superheat]
[6, Diag: Suction Press Sensor Failure]
[7, Diag: Suction Temp Sensor
Units with at least 1 [8, Diag: Frostat Aarm]
Compressor [9, Diag: Discharge Press Sensor
[10, Diag: High Pressure Cutout
[12, Diag: High Superheat]
[13, Warn: Cond Limit Active]
[14, Comp Locked Out]
[15, Warn: Frostat Limit Active]
[4, Diag: Safety Circuit Alarm]
[5, Diag: Low Superheat]
[6, Diag: Suction Press Sensor Failure]
[7, Diag: Suction Temp Sensor
Units with at least 2 [8, Diag: Frostat Aarm]
Compressors [9, Diag: Discharge Press Sensor
[10, Diag: High Pressure Cutout
[12, Diag: High Superheat]
[13, Warn: Cond Limit Active]
[14, Comp Locked Out]
[15, Warn: Frostat Limit Active]
[4, Diag: Safety Circuit Alarm]
[5, Diag: Low Superheat]
[6, Diag: Suction Press Sensor Failure]
[7, Diag: Suction Temp Sensor
Units with at least 3 [8, Diag: Frostat Aarm]
Compressors [9, Diag: Discharge Press Sensor
[10, Diag: High Pressure Cutout
[12, Diag: High Superheat]
[13, Warn: High Disc Press]
[14, Comp Locked Out]
[15, Warn: Frostat Warning]
Description
[1, Normal]
Read Only
1, Off]
[2, Starting]
[3, Running]
Failure]
Read Only
Failure]
Alarm]
[11, VFD Fault]
1, Off]
[2, Starting]
[3, Running]
Failure]
Read Only
Failure]
Alarm]
[11, VFD Fault]
[1, Off]
[2, Starting]
[3, Running]
Failure]
Read Only
Failure]
Alarm]
[11, VFD Fault]
BAS-SVP042A-EN
Read/
Write