Configuration - Trane Tracer UC600 Installation Manual

C C o o n n f f i i g g u u r r i i n n g g t t h h e e U U C C 6 6 0 0 0 0
3. Select D D i i r r e e c c t t C C o o n n n n e e c c t t i i o o n n ( ( U U S S B B c c a a b b l l e e ) ) if it is not already selected.
4. Click C C o o n n n n e e c c t t and the Unit Summary page displays after successful connection.

Configuration

To configure the UC600 controller:
1. Select the C C o o n n t t r r o o l l l l e e r r S S e e t t t t i i n n g g s s U U t t i i l l i i t t y y tab from right side of the Tracer TU window.
2. Enter a meaningful name for the controller.
3. Click C C o o n n t t r r o o l l l l e e r r U U n n i i t t s s to display its contents.
4. Select the preferred units of measure for data communicated across the BACnet link.
5. Click P P r r o o t t o o c c o o l l to display its contents.
6. Select the preferred B B a a u u d d R R a a t t e e in the drop-down list.
N N o o t t e e : : The UC600 device supports four baud rates: 9600, 19200, 38400, and 76800 baud. The
7. If the software Device ID is required, check U U s s e e S S o o f f t t w w a a r r e e D D e e v v i i c c e e I I D D and enter a BACnet
8. Click S S a a v v e e .
9. Cycle power to the device to have the new values take effect.
12
N N o o t t e e : : The content of this screen is based on the type of controller that is connected and the
system protocol used to communicate with the controller.
default baud rate is 76800 baud.
Device ID.
BAS-SVP042A-EN