Chapter 1 Safety Information; Safety Information - Read Before Installation And Applying Power; Contacting Rc Systems Inc - RC Systems ViewSmart 1600+ Operation Manual

Chapter 1 Safety Information
1.1 Safety Information – Read Before Installation and Applying Power
The following symbols are used in this manual to alert the user of important instrument operating issues:
This symbol is intended to alert the user to the presence of important operating and
!
maintenance (servicing) instructions.
This symbol is intended to alert the user to the presence of dangerous voltage within the
instrument enclosure that may be sufficient magnitude to constitute a risk of electric shock.
WARNINGS:
•
WARNING- EXPLOSION HAZARD - DO NOT REPLACE FUSE UNLESS POWER HAS BEEN SWITCHED
OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
• WARNING- EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN
SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
•
Shock Hazard - Disconnect or turn off power before servicing this instrument.
• Use a properly rated CERTIFIED AC power (mains) cable installed as per local or national codes
•
A certified AC power (mains) disconnect or circuit breaker should be mounted near the controller
and installed following applicable local and national codes. If a switch is used instead of a circuit
breaker, a properly rate CERTIFIED fuse or current limiter is required to be installed as per local
or national codes. Markings for positions of the switch or breaker should state (I) for on and (O)
for off.
• Clean only with a damp cloth without solvents.
•
Equipment not used as prescribed within this manual may impair overall safety.

1.2 Contacting RC Systems Inc.

To contact RC Systems Inc., call, fax, email or write:
409–986-9800 FAX 409-986-9880 Email: info@rcsystemsco.com
8621 Hwy. 6 Hitchcock, TX 77563
Or visit us on the Web at
UM-1097
Revision B
www.rcsystemsco.com
1