Gateway Configuration From The Scs - (Fxs); Ag/Sr 2330 - Gateway Configuration - Avaya SR 2330 Task Based Manual

AG 2330 Installation Reference
To configure the dialling plan in SCS:
1. From the SCS main interface, select System followed by Dial Plans.
2. Add a dial plan rule that references the unmanaged gateway added
above.
Note: For full details of Dial Plan Configurations, please refer to the SCS 4.0
System Configuration Task Based Guide.

Gateway Configuration from the SCS - (FXS)

The SCS system can be configured, so that gateway FXS ports can be used as an
extension on the system. This is particular useful for FAX machines or other
analog devices. This process is completed by adding a user to the SCS.
Note: For details of how to configure Users for the SCS please refer to the SCS
4.0 Configuring User Profiles Task Based Guide. General configuration details for
FXS Gateways are included in the SCS 4.0 Device Configuration – Gateways Task
Based Guide.

AG/SR 2330 - Gateway Configuration

To configure the Gateway please refer to the Advanced Gateway 2330
Commissioning documentation (NN47264-302).
When the AG2330 is powered up, the boot sequence displays messages on the
PC connected to the console port. A prompt displays at the beginning of the boot
sequence indicating that the auto-boot sequence can be stopped by pressing any
key. The AG2330 waits for 5 seconds for an input from the administrator before
beginning the boot sequence. If you press a key and stop the auto-boot sequence,
the AG2330 displays the boot rom command menu.
To logon to the AG2330 CLI for the first time, enter the default user name and
password:
 login: admin
 password: setup
Please note the following in relation to the steps outlined below:
1. Commands proceeded with # are comments provided to help the
administrator and are not required.
2. Parameters in yellow are configurable and unique for each customer
depending on the configuration.
16 NN40010-551 Issue 1.3 SCS 4.0